Williams air throttle part - Ebay?

[Paladin]

What do you guys think of this? Still need pedal and modulator if memory serves but a start for the price?


http://www.ebay.com/itm/WILLIAMS-CONTROLS-WM-388-U1C1D-117888-MCI-BUS-COACH-AIR-THROTTLE-CONTROL-/180986701443?pt=Other_Vehicle_Parts&hash=item2a23a5e683&vxp=mtr

[Eagle Andy]

That is a good start go for it  I had to make  my bracket the is on that one.you will love it when you get it done.

[luvrbus]

That is a universal control you need the pedal to match fwiw Andy is good at installing those he did it right the 1st time

[Eagle Andy]

Yes Clifford I did do it right the first time  However I had you to thank  for that. 

[Cary and Don]

Make sure that the pedal and the control BOTH have the same air pressure rating.  If not you will either have no throttle or a wide open throttle during application.  The part number on the housing will tell you. Experience speaking here.

Don and Cary

[luvrbus]

It really is the best to buy the control that is made for the DD 2 strokes it mounts on top of the governor housing no brackets to make or linkage to figure out fwiw

good luck

[Gary LaBombard]

Don,
I just received a Williams Air Control foot treadle with the numbers (WM-453-B) on the body.  Two weeks ago I purchased the ebay listing of the modulator I will call it that mounts at the engine that is also mentioned in this thread above.  This is a very, very good looking modulator too I might add and the price is wonderful too.  I plan to get another just for kicks or in case needed on the road and have a spare for the price. The instructions for the modulator mounted on the engine says to use (60 psi) but I do not have any instructions for the foot treadle I just received today.  With the knowledge you now have in your opinion should I use a pressure regulator for 60 psi or use the full pressure to have control of the foot pedal for speed of the engine etc?  so with the information I have given you, would you recommend full air pressure of the 1/4" line or 60 PSI??  Also, would you run 3/8" or 1/4" line from the front of the bus to the back Governor modulator??
Thanks ahead of time
Gary

[luvrbus]

Better check it out for clearance Gary sometimes they work on a 05 without and modifications above the panel sometimes it takes a little fab work lol