Allison B500 behind mechanical Cummins L10

[NeoplanAN440]

i found a b500 that came from a Detroit S60.
my idea is to mount it to a Cummins l10.
i have seen b400 trannys coupled via TPS sensor as stand alone systems.

do i need a different ECU or can it be reprogrammed? or just change the wiring to tps without data bus??

i was searching for a whole combo to make it easier,but could only find find a mechanical L10 that are running with a HT740

[Eric]

BUMP!

[TomC]

You can run the B500 behind a mechanical engine, or an electronic engine without being hooked directly to the engine.  You just need a throttle position sensor and you'll be set.  The transmission will not shift as smoothly as when it is hooked directly to the engine, but it will work.  Good Luck, TomC

[NeoplanAN440]

so i can use the stock ecu???  (from the s60 setup)


im waiting on my service manual to get the wiring diagram and specs,
but im trying to gather some info before i buy the tranny!!

as said,would be easier if there had been a stock l10 b400 or b500 setup around.