Transmission cooler size - Page 4
 

Transmission cooler size

Started by bevans6, May 26, 2017, 06:29:03 AM

Previous topic - Next topic

TomC

I can tell you that the shell cooler is much smaller than the air to oil cooler. I had the 13spd manual taken out of my truck and an Allison HT740 installed. For cooling that put a huge cooler in front of the radiator. It is about 3ft tall by 1.5ft wide. Good Luck, TomC
Tom & Donna Christman. 1985 Kenworth 40ft Super C with garage. '77 AMGeneral 10240B; 8V-71TATAIC V730.

daddysgirl

Quote from: Dave5Cs on May 28, 2017, 12:52:45 PM
The extra roof on top of our Bus is because it is a Saudi Coach. Its just an extra piece over the original roof that air goes between to give it cooling when it was over there in 120 degree weather.

You should look into re- hooking up the fitting in the tool bay under the driver seat area. That is for a tow truck or hauler to hook up an air line to it , to release the brakes so he can move it if not fully aired up.HTH
Dave5Cs

That roof is too cool, literally and figuratively. I just finished the first insulation layer on the interior rear ceiling. I had to do that work before 7AM or after 8PM because the metal was so hot. But now that I finished the re-work of the the rear AC, I don't feel like I'm in an oven.

I agree with you on the fill valve. That tank has one line coming out of the end adjacent to the emergency valve (I'm assuming it will trace to the front leveling valve). That's it. No other lines connected to it, but I believe there is a plug on the other end.

If so, is there any reason I could not connect that end to the little valve, or should I modify the existing line? I need to clean up that tank...(the entire compartment really) anyway, but I'm not sure adding another hole is the best idea?

I need to look at the pipe in the rear also.
Andrea   Richmond, VA
1974 MC8 8V71/HT740 new in 2000 and again in 2019-