inverter terminology
 

inverter terminology

Started by Bob Gil, September 17, 2008, 11:52:24 AM

Previous topic - Next topic

Bob Gil

I am wondering what is meant when it is stated that the inverters are stacked?

I know it is not one mounted on top of the other.

I am assuming that they are both wired to the same curcit?

Please excuse my stupidity.

Bob
Fort Worth, Texas where GOD is so close you don't even need a phone!

1968 GM Bus of unknown model 6V53 engine (aftermarket) converted with house hold items.

Had small engine fire and had no 12 volt system at time of purchase. 
Coach is all 110 w 14KW diesel genrator

boogiethecat

Just like honda inverter generators, with some extra control lines, some kinds of inverters can be hooked together in parallel, "stacked" to get more power from a multiple bank of lower powered inverters...
1962 Crown
San Diego, Ca

jjrbus

There is so much terminology today that is foriegn, remember when a cat played with a "mouse", when stacked meant a lady looked like the front of a Caddy?
To publicly annouce that you do know something is a sign of strong self esteem and high intellegence, not stupidity.  Jim
Remember, even at a Mensa convention someone is the dumbest person in the room!

http://photobucket.com/buspictures

http://photobucket.com/buspictures

David Anderson

In my Trace manual stacking refers to wiring two inverters to achieve two 120 volt legs on opposite phases, ie. to give you a 240 volt circuit.   Good question.

David

pvcces

Some of these units are capable of parallel or serial stacking, IIRC. Trace SW4024 comes to mind as one of these.

For what it's worth.

Tom Caffrey
Tom Caffrey PD4106-2576
Suncatcher
Ketchikan, Alaska

Len Silva

Just be sure that they are indeed stackable.  There is usually a control lead between the units.  You cannot parallel any two inverters that are not designed for it.

Hand Made Gifts

Ignorance is only bliss to the ignorant.

TomC

To simplify- stacking is an electronic control that will synchronize two inverters to work as one-to keep the 60 cycles of AC in synch between the two.  Then they think as one and you double your output-but also double the need for more batteries.  I have seen as many as 16 8D batteries being used to power a bus-that's almost 2500lb of batteries.  Then you have to charge them up again.  Personally-use the inverter for convenience items, not for primary electricity.  Have 2-4 8D's, or 4-8 6volt batteries, use a single inverter for convenience items (like microwave, coffee maker, TV, Stereo, etc) and for your primary electricals, use the generator.  It'll weigh alot less-considering a 12kw genset weighs about 650lb and 4 8D's weigh about 600lb.  Good Luck, TomC
Tom & Donna Christman. 1985 Kenworth 40ft Super C with garage. '77 AMGeneral 10240B; 8V-71TATAIC V730.

luvrbus

My,Traces are stacked for 220 volt dumb to install a European type cook top but I am not the cook,Marathon uses 2 4000w stacked inverters with 6 4-D batteries

Bob Gil

Thanks that help me understand a lot of what i have been reading here.

Bob
Fort Worth, Texas where GOD is so close you don't even need a phone!

1968 GM Bus of unknown model 6V53 engine (aftermarket) converted with house hold items.

Had small engine fire and had no 12 volt system at time of purchase. 
Coach is all 110 w 14KW diesel genrator