50dn alternator issue.
 

50dn alternator issue.

Started by TheHollands!, June 05, 2019, 08:37:18 AM

Previous topic - Next topic

TheHollands!

Hi all,
I have a 50dn oil cooled alternator in my MCI-9. Iv'e recently noticed that when I'm pulling an incline from a stop and the engine is really under strain, that I have some oil spraying up onto the roof of the engine bay from what seems like the alternator. I can't figure out where exactly it's spraying from, I wish I could visualize it as its happening so as to know what I need to replace. It doesn't seem to do it when just running down the highway. I know its all a bit vague, is there a logical point this might be happening. The alternator seems to be charging fine, wondering if its best just to have it changed out, or would a shop be able to stage the situation and identify the leak better and maybe just need to replace a few parts. I feel like I'm talking myself through this but wanted any advice from you all. Thanks, Craig
The Hollands!
1984 MCI-9
www.tillersandtravelers.wordpress.com
Musical Nomads

bevans6

MC-9 gear driven alt drains and vents to the gear drive housing, so it's internals are basically identical in pressure to the inside of the gear drive housing, which is to say atmosphere but vented to the crankcase.  If the engine is working very hard, you could have a lot of blow-by pressurizing the crankcase, hence the gear drive housing hence the alternator, but that is a bit of a stretch.  Might just be a bad gasket, after all.  Not only is the engine working hard in such conditions, it is probably running at higher rpm than normal, running up to governed limit in lower gears, etc, and oil flung off of gears can get everywhere.
1980 MCI MC-5C, 8V-71T from a M-110 self propelled howitzer
Allison MT-647
Tatamagouche, Nova Scotia

Utahclaimjumper

 It sounds like you want to just throw parts at it until the problem goes away,,start by tightening various end cap bolts,,mounting bolts ,, check gaskets,, oil fittings and lines and items around the problem area like maybe an oil manifold in the area and that sort of thing.>>>Dan
Utclmjmpr  (rufcmpn)
EX 4106 (presently SOB)
Cedar City, Ut.
72 VW Baja towed

TheHollands!

Thanks for the input, I'll start by tightening everything and looking it over close once I get parked in the next couple of days. I'd love to mount a camera back there to see whats going on. I may try rig something up. Craig
The Hollands!
1984 MCI-9
www.tillersandtravelers.wordpress.com
Musical Nomads

chessie4905

If it has that little oil line, maybe it's  leaking, or the oil line.
GMC h8h 649#028 (4905)
Pennsylvania-central

richard5933

This might sound oddball, but could a worn-out engine mount(s) be causing this?

My thinking is that when under heavy load the engine is more likely to want to move, and if you have a hairline crack or lose oil line somewhere that movement may open the leak enough to cause it to shoot all over the place.
Richard
1974 GMC P8M4108a-125 Custom Coach "Land Cruiser" (Sold)
1964 GM PD4106-2412 (Former Bus)
1994 Airstream Excella 25-ft w/ 1999 Suburban 2500
Located in beautiful Wisconsin

Geoff

The oil could be coming from the oil feed line to the blower.
Geoff
'82 RTS AZ

TheHollands!

I have an update for you all. Iv'e found that the oil is actually transmission oil squirting out of the dipstick tube on shutdown, maybe other times too. It ends up landing on the alternator, hence why I thought it originated around there. Would this be simply needing to replace the dipstick to get a better seal, or is this a bigger problem? Thanks for all your ideas. Craig
The Hollands!
1984 MCI-9
www.tillersandtravelers.wordpress.com
Musical Nomads

neoneddy

Also check the fan miter box fluid level.  I had oil spray right above and on my alternator for a while.  The vent / overflow for that spray oil into the fans, the fan whip the oil down and back.  Took me almost a year to figure that out, all the while thinking my dark sight glass meant the level was low, doh!

Hop up there and see if the vent is clean and shiny like it's been wet from oil.
Raising hell in Elk River, MN

1982 MCI MC9

6V92 / 4 Speed Auto (HT740) Video Build Log - Bus Conversion & RV Solar company we now started thanks to our Bus

TheHollands!

Hi Neoneddy,
Thanks for the idea, I'll take a look just to make sure. I did find the main culprit was a bad transmission dipstick that was spraying oil on shutdown. Iv'e found owning this bus has been real fun trying to learn and trace all the different systems and odd things that can go wrong. Overall, Iv'e been amazed at how reliable these old buses are, at least mine has been quite terrific over the years in what it has enabled us to do. For a cheap platform to convert out a home that we've been able to travel in for 8 years, the repair costs can be a little hefty but not ridiculous considering all the moving parts and the hauling these things do. Big thanks to all on those on these boards that help problem solve the mishaps. Thanks, Craig
The Hollands!
1984 MCI-9
www.tillersandtravelers.wordpress.com
Musical Nomads

Oonrahnjay

Quote from: TheHollands! on June 18, 2019, 07:10:11 AM...  I did find the main culprit was a bad transmission dipstick that was spraying oil on shutdown.
....   Big thanks to all on those on these boards that help problem solve the mishaps. Thanks, Craig

     Glad you got there, Craig.  Wishing you many good miles; thanks for sharing the info and appreciation.
Bruce H; Wallace (near Wilmington) NC
1976 Daimler (British) Double-Decker Bus; 34' long

(New Email -- brucebearnc@ (theGoogle gmail place) .com)