Still trying to reach the power steering pump on a 8v92
 

Still trying to reach the power steering pump on a 8v92

Started by SanyikaV, June 18, 2018, 09:29:11 AM

Previous topic - Next topic

SanyikaV

Would it be possible to reach the pump on the forward (front) of the engine going thru the opening of the radiator (removed) ? I don't see how anyone can possibly go over the batteries on the passenger side to get to the pump. Any ideas ? This is a 1991 Marathon Prevost

PP

My PS pump is on the RH side behind the bats also and I can access it by either removing the house bats or laying something over the bats and stretching out on it. Your's might be different though since it is a few years newer.
Will

muldoonman

That's the way I got to it when my pump started leaking just sitting in barn. Over the batteries (covered with cardboard) and squeezing in and thank goodness for long arms. Very tight fit for sure.   Just o ring fix, purchased from Prevost on mine. That was about 3 or 4 years ago. A skinny mechanic would  fit. I'm 6'2" and about 240. It was tight.

Jon

If the bed is a north-south orientation you likely have easy access beneath the bed to a panel Prevost installs in the floor, that when removed gives direct access to the pump, compressor and alternator.
Jon

Current coach 2006 Prevost, Liberty conversion
Knoxville, TN

luvrbus

You need some long arms to reach the PS pump from the hatch or stand on your head,I remove the batteries
Life is short drink the good wine first

chessie4905

The power steering pump on my 4905 is right there on back of engine. Just open tailgate and there it is...lol
GMC h8h 649#028 (4905)
Pennsylvania-central

muldoonman

Quote from: Jon on June 20, 2018, 11:42:02 AM
If the bed is a north-south orientation you likely have easy access beneath the bed to a panel Prevost installs in the floor, that when removed gives direct access to the pump, compressor and alternator.

My cabinet maker converter (Cole Custom Coach) built the bed frame solid to coach and there was no access to engine. Had to go in from above batteries. A pita.

luvrbus

Quote from: chessie4905 on June 20, 2018, 01:08:21 PM
The power steering pump on my 4905 is right there on back of engine. Just open tailgate and there it is...lol

Yea but these guys can see the starter
Life is short drink the good wine first

chessie4905

I wonder which is worse to access...my starter or his power steering pump?....
GMC h8h 649#028 (4905)
Pennsylvania-central

robertglines1

I  moved batt on my 89 xl pulled the pin in end of pump.  pulled plunger set changed o-ring put back. right side motor looking at it from open rear door
Bob@Judy  98 XLE prevost with 3 slides --Home done---last one! SW INdiana

luvrbus

Quote from: chessie4905 on June 21, 2018, 04:30:07 AM
I wonder which is worse to access...my starter or his power steering pump?....

your starter wins hand down
Life is short drink the good wine first

TomC

This is one of the many reasons originally for a V-drive. Everything on the engine, except the oil cooler and the starter, are accessible. Then all buses now are T-drive. Especially with 2 stroke engines, that puts the alternator, power steering pump, air compressor on the back of the engine-which is facing forward and buried in the bus. I've seen a few home made T-drive conversions-mostly on 4104's where the converter made side access doors to easily get access to the back of the engine. Good Luck, TomC
Tom & Donna Christman. 1985 Kenworth 40ft Super C with garage. '77 AMGeneral 10240B; 8V-71TATAIC V730.

luvrbus

Life is short drink the good wine first

TomC

Yes I agree that water pumps are also hard on V-drives. That's why I just replaced mine when I had the radiator out for enlargement. With the radiator out, no problem. Good Luck, TomC
Tom & Donna Christman. 1985 Kenworth 40ft Super C with garage. '77 AMGeneral 10240B; 8V-71TATAIC V730.

chessie4905

On 4905, the radiator is hinged. Drain coolant, remove rear bolts, disconnect rad hoses and swing out on hinges.
GMC h8h 649#028 (4905)
Pennsylvania-central