Uh oh. I may need a front axle for 4106

[chessie4905]

Let us know when the bit or easy out breaks.btdt

[bigred]

         If you can transport the axle,I would transport it to a good machine shop .They will have drill presses and ways to block this thing to where it won' t move while it is being worked on,which is of utmost importance .These fellows are miracle workers 

[kyle4501]

If the threads are stuck so tight that the head of the bolt wrung off, I have never had any success with an e-z out.

I have had success with welding onto the stub sticking out to get it as hot as possible (and give the vice grips something to grip) - then turn it with the vice grips until it sticks again. Weld on it some more & repeat . . . .

A snug fitting washer helps keep the weld off the tapped part . . .

Good luck !