Does anyone have an early MCI parts manual that can look up a number?

Jeff Willard · November 14, 2016, 10:41:55 AM

Hey. do any of you MCI guys have a Parts manual for an MCI 9 laying around and can look up a part number for me? I found what I'm looking for in the maintenance manual on page 15-6, Figure 15-13 item#19 - Spacer but I need the actual part number so I can source it.
Thanks
Jeff

Paso One · November 14, 2016, 11:29:23 AM

I have a MCI 9 parts manual open on my desk printed 9-1-90 but the maintenance manual page # doesn't coincide with what you call item 19 tell me what component and I will look that way.

Jeff Willard · November 14, 2016, 11:46:51 AM

I think the online Maintenance manual page I was looking at is older than yours. It's called a "Spacer" and goes on the front Spindle to space the inner bearing out and the seal rides on the outer side
I attached a jpeg of the parts diagram
Thanks for looking
Jeff

Jeff Willard · November 14, 2016, 11:47:21 AM

#19 in that image

Paso One · November 14, 2016, 12:29:04 PM

My book calls it a oil slinger part# 15J-2-18

Jeff Willard · November 14, 2016, 12:37:27 PM

I just looked that number up and it shows it as the oil seal and in the page I have the "Slinger" shows a number of bolt holes in it that I believe is to keep oil off the brakes if the seal leaks. I'm looking for the ring that shows up between the seal and the slinger

Paso One · November 14, 2016, 12:47:20 PM

opps your right oil slinger 15C-2-9 I was also on the trailing axle view

Jeff Willard · November 14, 2016, 01:04:39 PM

I've found that number but I think it should be called a "Spacer" not a "Slinger". I found one outfit that listed the number 15C-2-9 but... it (a) shows as a "Slinger" and (b) it only weighs .2 lbs. That weight seems about right for a stamped metal slinger but it's a bit light for this Spacer which is a machined chunk of steel. Of coruse nobody shows pictures anymore. grrrrr.

Jeff Willard · November 14, 2016, 01:12:11 PM

Do you see a 15C-2-10 by chance? I found that and it's (a) called a Spacer and (b)weighs 1.3 lbs and seems to cost about right at about $50. The 15C-2-9 was only $14

Paso One · November 14, 2016, 01:17:04 PM

Yes on a different page 15C-2-10 does show up as a spacer.
I can e'mail or text the pages to you they were too large to attach here.

Jeff Willard · November 14, 2016, 01:40:19 PM

I think I figured it out. I just ordered them and I'll compare them to the originals when they show up. I'm 99% sure they're correct. I called the vendor and the inside and outside dimensions are all correct.
Thanks for looking. I appreciate it.
Jeff