I Need I Need
 

I Need I Need

Started by Beatenbo, January 12, 2007, 06:51:22 PM

Previous topic - Next topic

Beatenbo

A lot of folks do away with bus heat and air and remove compressor, condenser, ect. I need a main blower/fan assembly for a 102 A,B or C  that is located in the compartment in front in the first bay. Of course if you drop coach air and keep heat you will need this blower. I would like to find one in the SE I could pickup as this would be a hard item to ship Thanks for reading. Charlie B. ;D

Homegrowndiesel

What gave up with it Charlie?

Bearings, brushes, burned commutator, toasted coils?

Inquiring minds want to know.

Bill
Aerodynamic Eagle & MCI 102a3, 102d3 and NABI series 50 transit. Busnut x4

captain ron

I believe there's one on ebay, search mci

Beatenbo

Bill, It hasn't died, it just has a vibration. Probaly just bearings, but hard to find any one to deal with this kind of thing. Thanks

Beatenbo

c ron I think what you saw on ebay was rear engine rad blowers box.  I usually check ebay about every day for MCI Thanks.

TomC

Try some clip on tire weights.  You can experiment with them to get most of the vibration out with them.  Good Luck, TomC
Tom & Donna Christman. 1985 Kenworth 40ft Super C with garage. '77 AMGeneral 10240B; 8V-71TATAIC V730.

Tom Y

Charlie, I have one from a 80 5C.  Its been sitting out so it may be junk and that is where it is going when I find the time. You can have but I am in NW PA.  Tom Y
Tom Yaegle

Beatenbo

Hey Tom, I come up your way every now and then. If it's been left out in the weather it may be bad. Thanks Charlie

Kwajdiver

Charlie,

I'm planning on taking my heater blowers out in the next couple weeks.

Bill
MCI-9
1984

Still in Mobile
Auburndale, Florida
MCI-9
V-6-92 Detroit, Allison 5 spd auto
Kwajalein Atoll, RMI