1990 Prevost for Buy it Now $79K

[NJT5047]

Sure.  What do you want....just service doors?  or radiator door also?  
I saw your earlier post on the subject, but forget what you wish to do. ...something related an MC5?  
When you need this?  I'll do it tomorrow for you.   It's cold outside, I'm sorta underdressed to go trekkin to the bus house...but I will tomorrow.  
Are you going to try to use the doors off a 9?  May work...dfinitely could be cut down.   And they would be cheap to find.
Let me know and if you are still around, I may be talked onto doing it right now.  Take 10 minutes.
JR

[NJT5047]

Sure.  What do you want....just service doors?  or radiator door also? 
I saw your earlier post on the subject, but forget what you wish to do. ...something related an MC5? 
When you need this?  I'll do it tomorrow for you.   It's cold outside, I'm sorta underdressed to go trekkin to the bus house...but I will tomorrow. 
Are you going to try to use the doors off a 9?  May work...dfinitely could be cut down.   And they would be cheap to find.
Let me know and if you are still around, I may be talked onto doing it right now.  Take 10 minutes.
JR

JR, Any chance I can get you to measure your engine doors for height and width opening? Thanks Tom Y

Check back in 15 minutes....I'll have your dimensions.   JR

[NJT5047]

JR, Any chance I can get you to measure your engine doors for height and width opening? Thanks Tom Y

Here goes:  LH (air filter) and RH (Ac) side service doors are 34 1/2" high X 24 3/4" wide. 
The rear engine access doors are:  26 1/2" wide X 35 1/2 high....and this is times two doors. 
The radiator door is:  53" wide X 22" high.  The width of the radiator door is the same as the combined width of the service doors.
Let me know if you need more.
JR

[Tom Y]

JR, Thanks, Thanks,Thanks.  I have a 5c and need taller rear doors.  So I was hoping the 9s are tall enough, I need to go out to measure now.  Thanks Again  Tom Y

[NJT5047]

Well...the Prevost is gone.  They pulled the listing last nite at 10.  Still had the $65K offer.    Whatta deal!  Or so it seems. That bus would have been a deal without an engine.   
BTW, Tom Y...you're welcome.  Now we're gonna need some pix of your project.  What Cummins engine are you intalling?   
Cheerio, JR

[NewbeeMC9]

Yeah Tom  Y,

We'd love to heer/see/read what your upto

Enquiring minds and JR wanna Know

[Tom Y]

JR, I will post some pics on the picture page when I figure out how. I am putting a Cummins L10 in with a Allison. I am not an engineer but play one in my garage. So I am reluctant to say what I have done to this bus.  Thanks Tom