Tire pressure monitoring system purchase advice? - Page 3
 

Tire pressure monitoring system purchase advice?

Started by John316, February 07, 2011, 08:10:36 AM

Previous topic - Next topic

John316

Jim has a good point. Whenever we stop, I check the tires with my hand.

Now, I will say there are days when it is very hot, and I feel the tires. Then they might be a tad warmer then I can handle....
Sold - MCI 1995 DL3. DD S60 with a Allison B500.

technomadia

It appears as if the Pressure Pro sensors actually transmit temperature data as well, though with very coarse accuracy:

http://www.advantagepressurepro.com/images/Temperature_Measurement.pdf

They also seem to offer ways to get at the raw data stream from the monitor via RS-232, potentially useful for future geek projects.  Neat.

   - Chris
Cherie and Chris / Bus tour: www.technomadia.com/zephyr
Full-time 'Technomads' since 2006 (technology enabled nomads)

gus

Since my last post I turned on the Hopkins monitor again and it is wrong on every tire. Two are reading low by 14 psi and two are reading high by about the same amount?? Two are not reading at all!

It could be because I'm parked near two metal buildings, had that problem before but I'm going to call their tech support again.

If I can't get this corrected Jim may be hearing from me because I'm not going to be without them again.
PD4107-152
PD4104-1274
Ash Flat, AR

thomasinnv

check these guys out too, they've been around a little while and have good prices.
http://www.tsttruck.com/
Some are called, some are sent, some just got up and went.

1998 MCI 102-DL3
Series 60 12.7/Alison B500
95% converted (they're never really done, are they?)