Governed RPM setting for a 8V92T

[Doug1968]

Fellows,

What should the governed RPM setting be for my 86 8V92T?

How does one go about adjusting this setting?

Doug

[luvrbus]

Doug, mine is set at 2250 rpm no load the factory setting is 1900 or 2100 rpm I'll send you a email on how do it.
If you don't have a good electronic hand held no contact tack gun don't do it with the dash tack because they are not that accurate.
Anyway you can post a photo of the back of the governor housing so I can tell if you have a tamper proof one or not
Another way you can tell  on the left side on the back of the housing there is a cylinder looking thing about 4 inches long check and see if you can feel 2 bolt heads if so no problem but if you feel 1 bolt it may be a problem if the plug is still in it
good luck

[TomC]

2250rpm would be my choice as the highest no load setting for a 92 series.  92's do not like high rpm-compared to a 71 series that can be turned up to 2600rpm without problem (my 8V-71 is at 2400rpm).  Good Luck, TomC