Onan 5.5 Marquis
 

Onan 5.5 Marquis

Started by larryh, August 11, 2008, 08:56:08 PM

Previous topic - Next topic

larryh

I start and plug bus into generator and run for a hour or so each month. Well first of Month came and fired up gen as usual and low output turned off and plugged back into shore power.

Fired up gen again and only putting out 56 AC volts on 20 amp side nothing on 30 amp circuit.

Any idea's or answers I'm thinking spendy .

5.5 BGMFA26105G
E973689462

all connections taken apart and redone fuses ok breakers seem to be ok

Larry H

Savvy ponderable:
A cowboy's only afraid of two things:
havin' ta walk,
and the love of a good woman.
"This posting was generated using an environmentally friendly, self contained flatulence generator, therefore no fossils or neutrons were harmed in the creation of this posting.


Quartzsite,

niles500

check the output side of the breakers for 120 - HTH
(\__/)
(='.'=)
(")_(")  

- Niles

TomC

Either your brushes are bad or your exciter is.  Good Luck, TomC
Tom & Donna Christman. 1985 Kenworth 40ft Super C with garage. '77 AMGeneral 10240B; 8V-71TATAIC V730.

larryh

Niles I gave what I have on output side56volts on 20 amp side nothing on 30 amp side.

LarryH
Savvy ponderable:
A cowboy's only afraid of two things:
havin' ta walk,
and the love of a good woman.
"This posting was generated using an environmentally friendly, self contained flatulence generator, therefore no fossils or neutrons were harmed in the creation of this posting.


Quartzsite,

niles500

Then did you check the input side? - if it's the same outcome your right it does look spendy - for sure a 30 amp breaker would be the cheape$t outcome - GL
(\__/)
(='.'=)
(")_(")  

- Niles