Question about pocket doors

[BJ]

I have a great working and looking pocket door in my MC8. Build the one wall, then buy the pocket door hardware from HD, measure the opening to be around, oh roughly 32 inches mount the door hardware approx 2 inches or so from the ceiling (on a cross member) hang you door to the hardware, slide it to its closing side and measure where to cut the corner. you should not be able to see the cut unless the door opening is to large. finish off your walls, bracing the door side at the top and bottom real sturdy... mount your bottom slider a little tight and the door won't open and close going around corners. It is really a very simple thing to do once you start and get into it, the construction that is. The hard part is finding a nice pull for the smaller piece of wood you are suing for the door. Took a lot of searching and I don't remember where I finally found it. But I will go back through some catalogs..have fun

[NewbeeMC9]

How about something like this


http://www.phantomscreens.com/content/slide1.php


you could order the screen none transparent, or just use the screen and keep the bugs on the other side of the bus.