DIY on ythe cheap
 

DIY on ythe cheap

Started by windtrader, January 09, 2021, 11:45:58 PM

Previous topic - Next topic

windtrader

Watched these go by today and thought they would work fine for fresh water and gray/black tanks. Not the best size but the price is right to get a bus converted on the cheap
And the bus to get started. They looked alright. If the motor was running, that alone covers the cost.
Don F
1976 MCI/TMC MC-8 #1286
Fully converted
Bought 2017

Bill Gerrie

Okay for black and grey but don't use aluminum for the fresh water tank.

richard5933

Quote from: Bill Gerrie on January 10, 2021, 10:42:21 AM
Okay for black and grey but don't use aluminum for the fresh water tank.

Especially one that held diesel. Can't imagine it's possible to ever fully get that out.
Richard
1974 GMC P8M4108a-125 Custom Coach "Land Cruiser" (Sold)
1964 GM PD4106-2412 (Former Bus)
1994 Airstream Excella 25-ft w/ 1999 Suburban 2500
Located in beautiful Wisconsin

luvrbus

Sewer will corrode aluminum they will start leaking in the seams over time,it was always a problem in boats but so was stainless   
Life is short drink the good wine first

windtrader

Maybe clean well then coat inside with a bio-safe sealant. There must be product around to do that without too much cost. Remember, this is not the best option but may be a very cheap and acceptable option if the inside can be safely coated.
Don F
1976 MCI/TMC MC-8 #1286
Fully converted
Bought 2017

chessie4905

Don't even think of one of those for water. Consider plastic tank.  Consolidated plastics makes hundreds of different plastic containers.
GMC h8h 649#028 (4905)
Pennsylvania-central

pabusnut

Yes, they are cheap!  Another consideration is how well the limited bay space is used.  I initially considered using plastic 55 gal drums until I calculated how much "wasted" space I would be using.  I eventually went with rectangualar tanks that allowed me to use my bay space more efficiently. 

I am only using one bay for all my water tank and pump, and waste tanks.  I also have my propane system, and my 12 VDC and 120 VAC distribution panels in that same bay.

This leave 2 full bays to available to haul other stuff around!

To each his own.  I am very cheap, but wasted space must be assigned a cost also. 
Tanks are not something you want to have to re-do on the road later.
Steve Toomey
PAbusnut

Jim Blackwood

Tank coatings are troublesome and coating aluminum with anything is prone to failure. So here's a cheap quick fix that is likely to cost more in the long run than just doing it right the first time. Also ingesting aluminum has a possible link to Alzheimer's and we don't need that.

Jim
I saw it on the Internet. It MUST be true...

windtrader

OK, I think I'll chop one in half and make an outdoor BBQ grill? lol
Don F
1976 MCI/TMC MC-8 #1286
Fully converted
Bought 2017