DDEC II fast idle resistors?

[Iceni John]

Does anyone here know the ohms of the resistor(s) that DDEC II uses to bump the revs up to about 1100 RPM for fast idle?   I need to replace my resistors (why does my bus use two?) because their leads have corroded, but their color bands have worn off and my DDEC schematic doesn't clearly show their ohm values.   I also have a Kenworth/Peterbilt DDEC II schematic, but that doesn't show their ohms either.

Thanks, John

[Bill Gerrie]

Attached are the tables to calculate the desired RPM on fast idle

[Iceni John]

Bill, thank you SO MUCH!   That's exactly what I was looking for.
Just out of curiosity, from what manual are those three pages?

John

[Bill Gerrie]

John
They are in the DDECII Application and Installation manual.