Most obvious question ever asked? - Page 2
 

Most obvious question ever asked?

Started by daddysgirl, January 05, 2017, 03:23:10 PM

Previous topic - Next topic

Scott & Heather

Waiting with bated breath for pictures!!! :)


Sent from my iPhone using Tapatalk
Scott & Heather
1984 MCI 9 6V92-turbo with 9 inch roof raise (SOLD)
1992 MCI 102C3 8v92-turbo with 8 inch roof raise CURRENT HOME
Click link for 900 photos of our 1st bus conversion:
https://goo.gl/photos/GVtNRniG2RBXPuXW9

ol713

   Hi;
     A little off the subject, but check under the bus to see if you have
     a little fuel leak.   My bus also has the aux tank and fixing the leak
     was a real PITA.  The coupling hoses had deteriorated after only 40 years.
     Yes - - -  the aux tank is on the aft wall of the front baggage bay. Also
     the connecting lines run under the bus.
                                                  Merle.

daddysgirl

I'm on my way to snap a pic...although I'm thinking Warrior was right. BUT

How many of you (throughout the years of our busnut hobbing) have planned a fix for a problem, and when 3/4 finished with it realized the entire significance of what you're fixing? Not repairing an unknown part, but basing your plans off of the schematics that don't always represent well?

Well, I have experienced this feeling now, and as ignorant as you all might think I am... Here's one to ponder while I snap a pic:

As most of you know, I've been working on the electrical system when the weather is nice. I've also been re-doing the interior when the weather is bad. Well, it's been raining here for about a week (when I had time for bus work) so the roof heaters are on and I'm working on the front lower floor and the ducts. Two new return ducts, roughly 1/2 all scrubbed and I find two layers of white styrofoam with remanents of red paint running along each side of the aisle on what the book lists as the entire front bogie. OK, clearly a very important item. But I am aware of what happens after 40+ years when styrofoam sits on metal, so I pull it out and find a little bit of rust. As I'm finishing the "rust-rid" and resurface, It dawned on me that this was the top of the two front air beams.
The small channel that closes the bogie along the wheel line (to the outside) was in bad shape, but as I was feeling around, it was rounded to the exterior where it goes down behind the tire. I have NEVER been so glad that I didn't use a drill, and that I caught it when I did.

Ok...on to the picture...be back soon.

Andrea   Richmond, VA
1974 MC8 8V71/HT740 new in 2000 and again in 2019-

daddysgirl

I do believe the Warrior was correct, as usual :)
I don't know why I thought these were tanks. But in my defense, the darn parts book should show the frame, and/or the fuel tanks themselves.
Andrea   Richmond, VA
1974 MC8 8V71/HT740 new in 2000 and again in 2019-

Scott & Heather

Yep. Lol them are the stairs. Don't even think of being embarrassed. Converting a bus isn't for the faint of heart. I've done two and I'm 34 and I'll never do it again. In fact there's a good number on this forum who haven't done their own conversion from the ground up so you are part of an elite group. And if you complete the conversion and actually go out and use it, you're part of an even smaller group lol. So consider this bus college and by the time you're done, you'll have your bus doctorate :) keep up the good work. Someday we will meet you :)


Sent from my iPhone using Tapatalk
Scott & Heather
1984 MCI 9 6V92-turbo with 9 inch roof raise (SOLD)
1992 MCI 102C3 8v92-turbo with 8 inch roof raise CURRENT HOME
Click link for 900 photos of our 1st bus conversion:
https://goo.gl/photos/GVtNRniG2RBXPuXW9

daddysgirl

Thanks Scott!

My problem is that when we did this bus the first time (and the other two previous) I didn't address this stuff. My job was building the interior systems and maintaining the engine.
I really appreciate the kind words. When I went back and looked...I was kicking myself, but you're right. And I absolutely WILL finish this remodel, even if it takes another year, and five more obvious questions.

I would love to meet you and Heather...something to help me work through the PITA's...hitting the road to meet some fellow busnuts, even without a Bluegrass festival :)
Andrea   Richmond, VA
1974 MC8 8V71/HT740 new in 2000 and again in 2019-

Seangie

Quote from: daddysgirl on January 06, 2017, 11:22:19 AM
I do believe the Warrior was correct, as usual :)
I don't know why I thought these were tanks. But in my defense, the darn parts book should show the frame, and/or the fuel tanks themselves.
I was hoping for a custom holding tank so the driver could relieve himself without having to slow down.....
'Cause you know we,
we live in a van (Eagle 10 Suburban)
Driving through the night
To that old promised land'

daddysgirl

Ya know, that's not a bad idea.
I could add a tank and attach it to the windshield washer tank. Now, if only I was man...that's not a bad idea. :)
Andrea   Richmond, VA
1974 MC8 8V71/HT740 new in 2000 and again in 2019-

tuccitown

-------------------------------------------------------------------------
1979 GMC H8H649-053 Conversion in progress.
1955 GM PD 4501-377 Converted.
-------------------------------------------------------------------------

daddysgirl

OMG...I love that!
If there's one that can be used while sitting, I'll be a happy "girl" lol!
But can you imagine the looks I would get from passing truckers (who look at me three times as it is...female driving a bus) if I were standing there, driving happily down the road...standing up and peeing? I'd bet a cop would never even stop me :)The mere thought gives me a much-needed smile...Thanks!
Andrea   Richmond, VA
1974 MC8 8V71/HT740 new in 2000 and again in 2019-

bigred

One thing I can tell you ,when you are planning a repair on a 20+ year old bus ,you may as well plan on doing at least four or more repairs in order to fix the repair you are planning.Have a situation with the factory installed  water heaters .Tore into the water compartment checked the heating elements and they were bad .No problem !! Loosen 4 bolts r/r the elements,Right?? H--- No !!! The PO had started this repair and had all ready stripped the threads from the bottom heater .Started to remove the upper element all the while fuming about the stupid but head that had stripped the threads on the lower element ,I started to loosen the bolts on the upper element .When I backed the bolts out ,it stripped the threads out of three of the holes .Seems the steel bolts have set up a reaction over the years with the alum heaters.I guess in 1994 ,anti seize compound had never been heard lol !! Anyway looks like I have three options .drill and retap ,Helicoil ,or new heaters .Can you helicoil anything as 1/4 in in cast alum?? Don't mind the price of new heaters so much ,but the r/r is going to be a royal pita!!
Rhet Raby           137 Elk Mtn Rd       Asheville N c 28804             1993 Prevost XL

buswarrior

It is really easy to get all turned around when you are under/inside/upside down a fresh vehicle, tearing into it.

Top marks for a clear written description of the objects in question, you led me right there!

Beware the curse of already knowing a lot: unwittingly, inside out head, the deciding mind, which thinks it is smart, jumps to a plausible conclusion, and then, because it is so smart, mentally skips points in the analysis or diagnostic sequence that might save oneself along the way... the part of our head that enjoys curiosity and new discoveries is so excited at all this, starts cheering wildly, so that the noise that the skeptical part of the head is shouting goes unheeded.

The only way to stop embarrassing ourselves, is to stop doing new things?

Some call that "hanging around, doing nothing, waiting for..."

happy coaching!
buswarrior

Frozen North, Greater Toronto Area
new project: 1995 MCI 102D3, Cat 3176b, Eaton Autoshift

DoubleEagle

Quote from: buswarrior on January 07, 2017, 01:55:54 PM

Beware the curse of already knowing a lot: unwittingly, inside out head, the deciding mind, which thinks it is smart, jumps to a plausible conclusion, and then, because it is so smart, mentally skips points in the analysis or diagnostic sequence that might save oneself along the way... the part of our head that enjoys curiosity and new discoveries is so excited at all this, starts cheering wildly, so that the noise that the skeptical part of the head is shouting goes unheeded.


That is a great assessment, I think it needs to be on a plaque hanging in everyone's shop! (Right next to the one that says " If a man says he will fix it, he will, there is no need to remind him every six months!").
Walter
Dayton, Ohio
1975 Silvereagle Model 05, 8V71, 4 speed Spicer
1982 Eagle Model 10, 6V92, 5 speed Spicer
1984 Eagle Model 10, 6V92 w/Jacobs, Allison HT740
1994 Eagle Model 15-45, Series 60 w/Jacobs, HT746

daddysgirl

Quote from: buswarrior on January 07, 2017, 01:55:54 PM
It is really easy to get all turned around when you are under/inside/upside down a fresh vehicle, tearing into it.

Top marks for a clear written description of the objects in question, you led me right there!

Beware the curse of already knowing a lot: unwittingly, inside out head, the deciding mind, which thinks it is smart, jumps to a plausible conclusion, and then, because it is so smart, mentally skips points in the analysis or diagnostic sequence that might save oneself along the way... the part of our head that enjoys curiosity and new discoveries is so excited at all this, starts cheering wildly, so that the noise that the skeptical part of the head is shouting goes unheeded.

The only way to stop embarrassing ourselves, is to stop doing new things?

Some call that "hanging around, doing nothing, waiting for..."

happy coaching!
buswarrior



AMEN.
It gets worse when you're so convinced you're right you tune out all other points/opinions. I am very lucky to have been raised by a smart man, but he knew he didn't know it all...he just acted like he did :) There are a few things I am confident I know but even with those things, you all have given me new ways of thinking that led to different ideas. Honestly, that is priceless, and I am incredibly grateful.
Andrea   Richmond, VA
1974 MC8 8V71/HT740 new in 2000 and again in 2019-