How to remove sikaflex

[Scott & Heather]

This is good info. Part of the issue is that the factory foam blocks behind the belt line portion of the skins are bowed out. This gives the coach a "pregnant" look which isn't quite what we're going for. So I may just pull the panels, remove the foam and install flat foam, and then put new panels on.


Sent from my iPhone using Tapatalk

[Seangie]

Scott -  Grab an embossing gun from Michael's for 20$.  Try that.  They get up to 650 degrees and its a good way to try it out before spending a whole lot of money and time.

[Scott & Heather]

Sean I might
Just use my heat gun on low


Sent from my iPhone using Tapatalk