Trailer Hitch Wiring Choices
 

Trailer Hitch Wiring Choices

Started by LuckyChow, July 02, 2015, 08:35:03 PM

Previous topic - Next topic

LuckyChow

I finally got the receiver hitch installed on my bus last week.  I need to install a connector to plug in lights for a trailer, platform hitch hauler, or towed vehicle.  I'm not sure what to go with these days, as there seems to be many more choices now than it was 15 years ago.  There are 6 blades, 7 blades,  6 pins, 7 pins, flats, combination units etc.  If anybody has a recommendation they really like, I'd appreciate a point in the right direction.  I'd like to find one that has a built in mounting flange so it can be mounted firmly somewhere under the bus/bumper.
Darryl
Smyrna GA
2000 Gillig Phantom

TomC

On my AMGeneral transit, I have the heavy rubber bumpers. I drilled a hole through the rubber, so the plug would not hang down and scrape. I used a 5 prong round plug since I have running, left turn, right turn, brake, ground. I also use two sets of LED magnetic lights. It only takes an extra 5 minutes to use these lights and because they are LED, are very bright. Good Luck, TomC
Tom & Donna Christman. 1985 Kenworth 40ft Super C with garage. '77 AMGeneral 10240B; 8V-71TATAIC V730.

Jim Eh.

If you are running electric brakes and do not want to go thru the effort of running a control wire from your brake controller to the receptacle at the back of the bus ....
http://www.tekonsha.com/products/brake-controllers/proportional-controllers/prodigy-rf/TzaIxkVx1cI5XOy!osRB508pViEKmVBf

A tad pricey but seems easy enough (kinda like a tax return form).
"Some days it's just not worth chewing through the restraints"
Jim Eh.
1996 MC12
6V92TA / HT741D
Winnipeg, MB.

boxcarOkie

Go for a 7 blade, easy replaced, if you need more capacity, it is built in.  Mount it high if you can, save yourself some grief.

BCO

Bill B /bus

Five pin round male covered connection in the bumper. Same on the tow vehicle. With a double ended female cable to connect the two. When removed it leaves a clean bumper with just the connection cover, air line connection and receiver.

Bill
Bill & Lynn
MCI102A3, Series 50 w/HT740


Lostranger

I standardized on 7 blade connectors about 20 years ago. I usually have a couple of trailers at a given time and one or two vehicles with towing capacity. The electrical connections work in any combination. I'll do the same when I get a hitch on Sophia.

LC, I've been trying to answer your email, but my outgoing mail server is not currently working. I'll get back to you asap. We're well and finally through with the nightmare month. Thanks for inquiring.

Jim
Jim H.
Marion, NC
1999 Gillig H2000LF
Yes Virginia,
You CAN convert a low floor.