Starting 8v71t after 20+? years - Many questions
 

Starting 8v71t after 20+? years - Many questions

Started by hunter97321, June 04, 2015, 10:36:36 AM

Previous topic - Next topic

hunter97321

My Grandparents converted a Silver Eagle bus in the 80's. Put in a re-manufactured 8v71T and an automatic transmission. Drove it about 3000 miles and then it was parked. They started it for a time (until the batteries went bad) and they moved to a condo in another state. Grandpa now has Alzheimer to some degree and I'm left to figure out what to do with the bus. We had it towed to a storage facility for now.  First time working with a diesel engine. I am not familiar with all of the controls required to start this beast. While I am not a mechanic by trade I can rebuild a gas engine and an automatic transmission.

It looks like it could be started from just the back using just this panel?https://www.dropbox.com/s/muraiw83acenmwo/Engine%20Panel%20Crop.jpg?dl=0 What do these controls do? Starting from top to bottom? Do I need to do anything at the front of the bus? When it was towed (about a mile from where it was parked) the driver pulled one of the drive axles out. Is it okay to start with that pulled? How can I tell if the transmission is in neutral or park? I am assuming that it is an open differential so the bus shouldn't go anywhere with the axle out. But, I would hate to mess up the anything else by having it rotate without the axle in place.

Many projects to do to get it up to par. Some of the cabinet doors will require some work as the glue dried out. Some rivets on the sheeting have failed. It is a pretty daunting project and while I am capable of most of the things myself I don't want to end up upside down with repair bills. Any advice is appreciated. Here are the pics I have so far.

https://www.dropbox.com/sh/pfzr1hyqgx3z4xi/AADFHHRgttpGALK3h64GgDJca?dl=0

RickB

STOP!!!! Don't turn that engine over with 20 year old fuel in it. You're gonna have to drain that somehow and the oil will have to be changed as well. I wouldn't do anything with that until after you've done those two things. If you just want to see if it will run, change the oil, replace and reprime the filters with fresh diesel and run it using a five gallon bucket as your fuel supply line. If you suck what's in those filters into that engine you will be sorry you did.

Best advice I've got

Rick
I will drive my Detroit hard... I will drive my Detroit hard.

eagle19952

Your bus is a model 01.
Someone will be able to give you some history if you post the serial/VIN #.
Those are your battery master switches. without new batteries can't say much other than they are in the on position.
In all likelihood, you would need the key on the dash in the on position to negate any obligatory shut downs in order to start in the rear.
The toggle in the picture may be a rear start sw. if it is a momentary spring loaded type, I am not positive as so many conversions are not "stock"
There are  more than a few 'busnuts" in Oregon.
There is every possibility in the world that your motor is "unharmed" 20 years idle, DD's are resilient.
You/I would not try to run the fuel that is in it nor the fuel filters.
Re priming them will be your first "hard" lesson.
Were I you I would do a complete suspension inspection before I put a dime in it.
There are a few Eagle Facebook pages that will also become an asset if you are FB savvy.

PS Nice Coach any idea who did the conversion ?
Donald PH
1978 Model 05 Eagle w/Torsilastic Suspension,8V71 N, DD, Allison on 24.5's 12kw Kubota.

moosemanusa

Just please please please video the startup!

Always great to hear old diesels come to life again!
RTS/Nova - Detroit50
Eldorado EZ-Rider - Cummins ISB
MCI-8 Crusader

Runcutter

Before one of the other members chimes in with one of our frequent suggestions, please add your location (see my signature line as an example).  It's quite possible one of our members lives close enough to give you a hand -- one of the great things about the folks on this board.

Arthur
Arthur Gaudet    Carrollton (Dallas area) Texas 
Former owner of a 1968 PD-4107

Working in the bus industry provides us a great opportunity - to be of service to others

HB of CJ

I completely agree about the fuel being very suspect.  But ... would one be able to save a buck by first having the oil analysed before dumping it?  It might be full of smog monsters and cooties ... or it may just need new oil filters?

Also I would inspect EVERYTHING in and under the Bus Conversion.  This would include looking inside the intake and exhaust systems.  Probably also a close inspection of the various belts and hoses might be a good idea.

As far as the coolant, again take a sample and have it analysed.  Anti freeze is spendy.  All you may have to do is change the coolant filters.  As far as the actual start up, make sure the rack is in the "stop" position first.

Then consider placing a strain on the starter and new batters cranking the engine up for about 30 seconds or so or until the oil pressure gage shows that the engine has been "pre lubricated" before firing the old girl up.

Hope this helps some.  It might be fairly cheap to get the Bus Conversion running.  Also good advice about the suspension and other specific stuff.  Might be a good idea to find a Bus mechanic with specific knowledge.   HB of CJ (old coot)

hunter97321

Went down and investigated a bit more, the toggle seems to head off towards the generator panel but, it goes into a loom about half way there. Checked the fuel level to see how much would have to be drained and of course....full....right to the top. I'll need to find some barrels. Fuel looks and smells like diesel. I need to take a day to clean up all the battery terminals and pick up some batteries for it...out of time for this week. Thanks for the feedback. I am in Albany Oregon.

HB of CJ

Wondering some more about that 20 year old diesel fuel.  It would probably be high sulfur which is bad.  Even it it checks out OK, the legalities of being caught with stinky fuel probably would not be worth the risk. 

But ... having said this, a hundred plus gallons of fuel is still very expensive.  Before I would dump it, is there any way it could also be analyzed?  Does it have any value?  Dunno.  Can it be filtered?  Bartered?  HB

luvrbus

I wouldn't worry to much about the old fuel,get sample kits from a Cat dealer and take samples of the fuel and oil, real diesel didn't go bad all that much if it is bad someone in your area can come out and polish it or you can do with a house water filter and a 12 volt pump    

Your biggest concern is going to be if the racks are frozen pull the valve covers to be sure they are free they should move freely by hand and turn the engine over by hand to be sure the plungers on the injectors are not stuck in the down position    
Life is short drink the good wine first

lostagain

Diesel fuel doesn't go stale like gasoline does. With a full tank, the moisture and or algae in it is probably negligible. I would run it with it. Just have a couple of sets of fuel filters with you. Take the valve covers off to make sure the injector racks are free and can return to no fuel position. Oil doesn't go stale either, I would start it with the oil that is in it, unless it looks really bad. You can change the oil shortly after. Make sure it is getting air (birds nest in air intake?). I would also take the oil feed to the turbo off and fill it with oil, then replace oil line. You don't want to run the turbo dry. I wouldn't fuss with it too much, just start it.

JC

PS I see luvrbus typed at the same time as me and is saying basically the same thing.
JC
Blackie AB
1977 MC5C, 6V92/HT740 (sold)
2007 Country Coach Magna, Cummins ISX (sold)

Charles in SC

Over the years I have read many "start up after sitting for years" stories. It always amazes me how many of them are fine and the new owner just takes off on a 1500 mile trip home in the thing. If there is a fuel wholesaler near by you might be able to tell something about the fuel condition if you can get them to do a flash test on it. If you can find a bus nut in your area they would probably love to come assist. There is a wealth of info from the members on this board. Good luck and keep us posted!
S8M 5303 built in 1969, converted in 2000

Boomer

I too would not worry about the fuel, especially at 3 bucks a gallon; use it.  You might crack the plug in the bottom of the tanks to see if any water comes out, but other than that, change filters, check for stuck injectors like luvrbus says, and go for it. I would also crack the pan plug and have a sample tested. FWIW, I recently started a 6-71 with 30 year old fuel, sitting without moving and burned every drop of it without a problem.
'81 Eagle 15/45, NO MORE
'47 GM PD3751-438, NO MORE
'65 Crown Atomic, NO MORE
'48 Kenworth W-1 highway coach, NO MORE
'93 Vogue IV, NO MORE
1964 PD4106-2846
North Idaho USA

eagle19952

now knowing the tank is full i am less concerned... does the coach have a generator....try starting it first. :)
Donald PH
1978 Model 05 Eagle w/Torsilastic Suspension,8V71 N, DD, Allison on 24.5's 12kw Kubota.

pvcces

We started one that had been setting for 15 years without any problem. The only thing we did was confirm that the rack was not stuck.

Good luck.



Tom Caffrey
Tom Caffrey PD4106-2576
Suncatcher
Ketchikan, Alaska

bevans6

I'm the "see if it is seized, make sure the injectors aren't stuck, and crank it" camp.  May not even have to prime the fuels system!

Brian
1980 MCI MC-5C, 8V-71T from a M-110 self propelled howitzer
Allison MT-647
Tatamagouche, Nova Scotia