How to insulate underneath coach? - Page 3
 

How to insulate underneath coach?

Started by Scott & Heather, September 30, 2012, 05:51:21 AM

Previous topic - Next topic

Scott & Heather

Yeah Bill...your kind of cold * oh my word, it's 60 outside! Turn on the hose heaters *

Eric, sometime we'll have to connect! Swap bus stories or something...or maybe we'll come live in your bus when ours freezes over.

UPDATE: We have had some 30 degree nights...soft freeze. Running a single 1500 watt space heater in the coach...and one in each of the two water bays...and we are staying toasty. Too toasty. The floors are really warm. That air is just heating the tiles from underneath and we are needing to turn down the heaters. So far so good...
Scott & Heather
1984 MCI 9 6V92-turbo with 9 inch roof raise (SOLD)
1992 MCI 102C3 8v92-turbo with 8 inch roof raise CURRENT HOME
Click link for 900 photos of our 1st bus conversion:
https://goo.gl/photos/GVtNRniG2RBXPuXW9

Eric

30 degrees around here and your taking off a layer or 2 come January ;)


Have fun !

Eric

Kwajdiver

When you say cold, you mean anything below 70degs.  All my Florida friends understand that 60 is 10 degs below freezing.....    ;D

Bill
Auburndale, Florida
MCI-9
V-6-92 Detroit, Allison 5 spd auto
Kwajalein Atoll, RMI

Scott & Heather

True story. Had a hard frost last night. Stayed toasty. Floors are warm too with heaters in the luggage bays :)


Sent from iPhone via Tapatalk
Scott & Heather
1984 MCI 9 6V92-turbo with 9 inch roof raise (SOLD)
1992 MCI 102C3 8v92-turbo with 8 inch roof raise CURRENT HOME
Click link for 900 photos of our 1st bus conversion:
https://goo.gl/photos/GVtNRniG2RBXPuXW9

robertglines1

Bay doors; I drilled a 3/16 holes   on about a 6 inch grid on inside and let the foam in a can do the job.  Just wait till it raises to the next hole in grid then put in more. You may need to skip around bay door handles and trim out excess later. Trim off extra foam after if sets up. Just a idea.  Work around frame and I did not experience any outside warping.  Bob
Bob@Judy  98 XLE prevost with 3 slides --Home done---last one! SW INdiana