12v rope light install help needed

[crown]

 got a 100 ft roll of 12 v rope lights now what ? i want to run 2 pieces down the center of bus about 30''
apart. so about 72,5 ft total can i conect this to one swith ? what size fuse ? what do you do to cut end ?
never worked with this stuff so need help ? thanks john

[Busted Knuckle]

John I have no idea about using rope light in the fashion you are using it.

Back when I was trucking I used to buy some from the chrome shops that came in like 10' strips and already had the ends on it and was ready to be hooked up. I just hooked two strips per switch on 25 A fuses.

Bob Glines might be able to shed more light on this as he's recently done the ceilings in his new project with it.
  BK 

[robertglines1]

Does your rope ligh have pictures of scissors ever couple feet or so? if so that's where you can cut it. Dead end cut off you can place a pin in and solder wire to and use else where.  I use the led strip lighting now in rolls 5 meter 300 per meter less than .08 amp draw.you can solder them end to end =12 volt(less than $20) e bay no heat like the rope lighting.  The rope lighting you will need to use the mechanical plactic fastners that came with it and tie wraps.-because of expansion and contraction.  Use what you got just anchor well.If you did not get plastic anchor with kit. Try electric tie wraps with the screw eyes already in they about every foot.  Nice to hear your back to bus building.   Bob

[crown]

 thanks bob the 100 ft roll came with about 50 clips and yes it is marked cut hear .it came with a few
wired ends with long leads. but where i cut it ? is that it. or do i need to conect the ends ? or something ?
what size fuse? or a relay ? how long can i go on one swith ? sore for all the thanks john

[robertglines1]

don't connect ends. it is not a continious loop.I  guessing it did not come with a transformer that takec 120 ac to 12 volt dc but are straight 12volt Dc. Unless otherwise specfied I would put a run that long on a 30 amp fuse(12 volt dc) These are not led correct? If they were led 4 amp would be more to correct size.   Bob

[crown]

hi bob these are direct 12v  all i known is these are called flexilight ? dont known if led ? thanks john

[robertglines1]

That product brand is led and is aprox .9 watt per/ft installed at 12 volt so your nearst 12 volt fuse would be 10 amp.   math calls for a fraction over 6amp plus margin=.Heat shouldn't be a problem.

[robertglines1]

pic of my led install

[crown]

 thanks bob if i get this installed i can finish my center roof panal with the buttons you made me i have used a
few on dash and door panal very nice thanks john
ps i tryed looking up flexilight but came up 0 do you known a web site ?