Bus ramps!

[steve5B]

   I thought I would let everyone know a friend of mine owns a local saw mill and I mentioned to him what it would cost to cut

   some large ramps for my bus.  I had read some where on the board awhile back that someone mentioned it was expensive.

   Around $50.00 a set he said.   I apologize if I'm not suppose to post this here.

   Steve 5B....

[jjrbus]

No need to apologize, good post.  I think "large" could be a little better defined.  Jim

[Len Silva]

I have learned somewhere that the ramps should be wide enough to accommodate both rear wheels.

[steve5B]

   Sorry, I forgot to mention the size, it was indeed the width of the rear wheels. So you could have the SAFTY for the front.


    Steve 5B.......

[Melbo]

I bought two railroad ties and cut them in half and beveled the ends

I put one under each of the drives and can just drive up on them and I usually carry them with me buried in a bay

HTH YMMV

Melbo