Welding Polypropylene

[Tom Y]

I am looking for sources for a welder, if that is what it is called. Also the rod material. I am trying to cut 3 tanks apart and making 2.  Thanks  Tom Y

[Hartley]

Cheapest: Harbor Freight.

They have a new one with the air pump built in.

But could have been Northern Tool. I forget now which.

Dave....

[Jerry Liebler]

Tom,
   Be sure to visit http://www.gumpydog.com/bus/MC9_WIP/Plumbing/Holding_Tank_Fabrication/holding_tank_fabrication.htm
before you start, craig's method of routing edges before welding is very helpful.
     Send me an off board email with your shipping address, phone #,  & how much rod you need.   I have several extra 1 # rolls of polypropylene rod which I'll send you for the cost of shipping.
Regards
Jerry 4107 1120

[Tom Y]

I looked at the 2 from Harbor Freight. Has anyone bought one of these? The one is 38.00. Where are you guys buying the rods at?  Thanks Tom Y

[luvrbus]

Tom, I buy my rod from www.arizonatools.com they have all types and that is were I bought my welder also   

good luck