brake rebuild

mikke60 · May 15, 2010, 08:00:52 PM

Hi, Anybody out there know where I can get a rebuild kit for my brake application valve? I have 1968 Mci 5a. Thanks mike

TomC · May 15, 2010, 11:23:48 PM

I would just buy a new one. Good Luck, TomC

mikke60 · May 16, 2010, 03:50:43 AM

I guess I could try to buy a new one ,but was trying to avoid a replumbing job. the unit I have now is obsolete. do you know if they sell dirrect replacement? thanks

zubzub · May 16, 2010, 05:11:00 AM

There are a lot of brake valves out there, you'll probably find something close. There is of course the option of pulling yours and seeing what's up before you throw it away....depends on timeframe.

mikke60 · May 16, 2010, 08:34:41 AM

pulled it, opened it. the 2 rubber seats in the inlet-exhaust valve show wear. this is causing a little blow by of air when brakes are not applied. Body looks to be in very good shape though. Would prefer to find rebuild kit, but a new one may be the only option.

zubzub · May 16, 2010, 10:08:42 AM

Luke's the go to guy forrevuild stuff like that. I would rebuild as well, I find it more satisfying....and educational.

LUKE at US COACH · May 18, 2010, 08:16:11 AM

Hi Mikke 60 & Folks:

If your application valve is the original, it would be an E-1. I have several out being rebuilt and should have them back in about a week. You can reach us toll free at: 1-888-262-2434.

I Hope this HELPS!!!

Happy & SAFE!! Bussin' to All.

LUKE at US COACH