Bearing/Hub Tool.

[johns4104s]

I have seen the disc with the two holes that is screwed down to hold the bearing in looking like it was tightend with a hammer and chisel. Where do I buy a wrench with the two claws to tighten the bearing correctly? Do large truck places carry them?

Thanks

John

[Dreamscape]

John, Try NAPA, if they don't have what you need they'll get it for you.

Good Luck,

~Paul~

[JackConrad]

Here is one I made from a scrap of 1" square tubing a couple big spikes (cut off) and a 7/16" nut.  All it took was a few minutes to drill 2 holes and a few tack welds to hold the pieces in place.

[gumpy]

Here's the one I made. I used a nut from the back of a wheel stud so I'd have something to put a socket on.

Jack's looks easier.