Thrust Bearing Lubrication

[LarryN 4106]

My lubrication hose to my clutch bearing (with zerk on the end of it) has become disconnected, and frankly I don't have any idea where it is. Is it possible to access the attach point where there is probably a part of the hose still attached? I could remove it and attach another. I do not have a lubrication "cup" as the manual shows. I would sure hate to have to remove the transmission just to get at that bearing. Thanks in advance.

[Sammy]

Larry,do you have an inspection cover on the bottom of the bellhousing?
Should be able to rotate the bearing (engine not running,of course) to locate the fitting.
I drilled a real tiny hole in one on a 1954 Flx Clipper, used the needle style adapter for my grease gun and shot some grease in it.
Found a real small rubber plug, good til the next PM.
Hope this might help you.