Refer monitoring software with 12 -24volt Danfoss compressors
 

Refer monitoring software with 12 -24volt Danfoss compressors

Started by Zeroclearance, June 20, 2010, 10:36:25 AM

Previous topic - Next topic

Zeroclearance

If anyone is interested in getting the most out of your refer.   Here is Danfoss new monitoring software.

http://www.ra.danfoss.com/TechnicalInfo/Literature/Manuals/06/bd_controller_101N08xx_12-24vdc_lin_gateway_quick_start_guide_07-2009_ps100n102.pdf

If money and time was growing off trees one could convert a newer "home" refer to these new compressors.

luvrbus

I had a Sun Frost that used that setup way better than the house type 110v fridge would run 2 days off a 12 v battery and I hear if hooked to a 24v system they will do better than that.



good luck
Life is short drink the good wine first

Nick Badame Refrig/ACC

Hi Zero,

I have been installing the Danfoss DC compressors for years and until now, they were not anymore efficient

then standard AC compressors. The new controller and software is getting them closer...

They really need to focus on Scroll type compressors and not hermetic, driven by DC. This will give them alot more efficency.

I have heard they have many in R&D but none for us as of yet..

Good post!
Nick-
Whatever it takes!-GITIT DONE! 
Commercial Refrigeration- Ice machines- Heating & Air/ Atlantic Custom Coach Inc.
Master Mason- Cannon Lodge #104
https://www.facebook.com/atlanticcustomcoach
www.atlanticcustomcoach.com

Zeroclearance

Nick;

Thanks for the reply.   What are your thoughts about a Danfoss compressor retrofit in a newer refer?   What is the cost of the Danfoss and control monitoring system.