First the alternators are 12 volt 160 amp. One dedicated to house batts, the other is coach charging. The reason for lack of rivets What you see added to the back is cosmetic for looks only. The engine is supported by all the original support points. I have some frame rail pictures that I need to scan. Although the engine is hanging back three feet further it is 800 hundred pounds lighter. The transmisson is much closer to the rear axle. I used six inch channel for frame rails,then used what I call bridge work to tie it together. The rear axle was a real challenge ( truck axle turned over ) more on that later. Pat
I thought you could just take the V drive pumpkin out of the rear axle and replace it with a straight drive? Good Luck, TomC
man I gotta tell after looking at all the pictures of the stretch job I feel lazy. beautiful job, very impressive.
guess I gotta get in gear and get something finished now.
steve
Quote from: TomC on July 22, 2008, 04:54:59 PM
I thought you could just take the V drive pumpkin out of the rear axle and replace it with a straight drive? Good Luck, TomC
I think the V drive rear end has the pumpkin offset from the centerline of the bus. Jack
Pat...thanks for many photos of the project. I am sure you put in many hours & effort into it.
Have 2 question:
1 Is the engine run counterclockwise?
2 Are you using transfer box?
I enjoy looking at your photos of nice work.
Sojourn for Christ, Jerry