I had to replace a high/low sealed beam on my Eagle and of course the light bezel mount which is plastic and 35 years old broke. So I had to make my own. I made it out of two pieces of 1" aluminum angle.
It was the outside bulb. Back in service. Now I have to figure out where to aim the beam.
https://www.summitracing.com/parts/oer-mn1775
Thanks for the link, Chessie,
but making that square hole in the edge of the light bucket wouldn't work on mine.
My fabricated part worked well. It didn't take too long to make.
David
There are many there, even ones that use screw mounts
Refreshing post, where someone solved their own problem without whimpering online, and then shared the results.
The collective project recovery knowledge has been expanded.
Thanks David.
Happy coaching!
Buswarrior