Does anyone know the pulse count per revolution of the output shaft for the world transmission B400? I'm programming cruise control on a DDEC2 and need the count.
Thanks
Dick Egler
Hello:
In the parts manual for b400 under SPI 13-WT-94 page 2 of 2 ; I found a changeout of parts from old to new output speed signal wheel. the new part is 29510781 . THis drawing shows 32 teeth on the wheel; (I cannot confirm if the drawing is an accurate reproduction but it looks full size.) Now I do not know how the sensor reads the wheel. Does it read both on and off pulses; or just on pulses which would indicate 32 pulses per rev. The troubleshooting manual talks about shaft rpms for overspeed control. Not sure this is what you want ... I have a b400R and will be looking at the signals in about a month to figure out how to interface it to the mci 7 cheers mike