23515497M Is front motor mount for a 60 series. What my problem is I don't know it's original application? I need to replace the rubber mounts between it and cross member. That is a custom application I fabricated to get more ground clearance in back. I have tried internet without any luck.
to further explain. I bought bus without engine cradle and no engine. I used the front mount on 60 serries that came out of truck. I found a different mount that will give me 3 more inches of ground clearance. Problem is I did not pay attention to what vehicle it came out of... i know senior moment!!~ now I want to install it and can"t figure out which isolator or rubber mounts to buy. It has 2 round holes on side about 2 inch diameter these would be extremely better! One of those I need to address that items. I do fab my own cross member so I want to have on hand before I start mod. Thanks Bob
Bob - does this help?
https://truckpartsinventory.com/portals/266/view-part/81545370?rt=nf
- Steve
Does the mount look like this?
http://hnctruckparts.com/shop-now/replacement-parts-and-components-for-international-trucks/international-trucks-engine-parts/engine-hard-parts/motor-mount-3515345c1-detail (http://hnctruckparts.com/shop-now/replacement-parts-and-components-for-international-trucks/international-trucks-engine-parts/engine-hard-parts/motor-mount-3515345c1-detail)
https://www.ryderfleetproducts.com/dorman-917-5102/heavy-duty-motor-mount-international-p-t49-9175102 (https://www.ryderfleetproducts.com/dorman-917-5102/heavy-duty-motor-mount-international-p-t49-9175102)
- Steve
Steve that's it! Thanks I was having a hard time for some reason... Double thanks!!!! Bob
Bob, those come in a marine grade also the marine grade sure helps with the rough idle on a series 60
Will order tomorrow. This looks like a better product than the set up I had. Marine Grade. Engine cross member was just a little low for my liking. About 2 1/2 inches below pan this will bring a little above pan bottom. Bob