Text only | Text with Images

BCM Community

Bus Discussion => Bus Topics ( click here for quick start! ) => Topic started by: Dietrichfarms on December 21, 2015, 01:59:58 PM

Title: Murphy EA160 generator control panel failure
Post by: Dietrichfarms on December 21, 2015, 01:59:58 PM
I have a Murphy EA160 control panel on my generator, that is not working. It is not sending
power to the fuel selanoid to allow for fuel on startup. I'm searching for a repair facility for
Murphy gauges/controllers . Any help would be great.
Title: Re: Murphy EA160 generator control panel failure
Post by: luvrbus on December 22, 2015, 04:20:47 AM
Call Murphy in Tulsa Ok they can tell you of repair center or who has the board in stock,that is a older controller it may not be repairable   
Title: Re: Murphy EA160 generator control panel failure
Post by: daddysgirl on December 22, 2015, 07:48:12 AM
This might be a stupid question, but if the fuel is really there (not gelled, etc) why can't you re-wire the solenoid to the panel?
Title: Re: Murphy EA160 generator control panel failure
Post by: wg4t50 on December 22, 2015, 10:24:38 AM
Have used Murphy controls, now we stick with DynAGen ES52 controllers, $175.00 area and they work, no issues, no excuses. Not everyone can set them up unless you think clearly.
Many options, settings, features.
Dave M,
Title: Re: Murphy EA160 generator control panel failure
Post by: Dietrichfarms on December 26, 2015, 07:26:38 AM
Talked with Murphy in Ok they had me go thru RES in FortWorth, Tx said thy could put different board in it even though it was obsoleted. Thanks for all the suggestions.
Text only | Text with Images