BCM Community
Bus Discussion => Bus Topics ( click here for quick start! ) => Topic started by: rusty on October 31, 2011, 07:23:34 AM
Bob, I did not want to hi-jack the silverleaf thread. If you go to the Eagle site, go to Project Eagles, go to my project (1994 model 15/45 by Wayne Schell) on page 7 is what I did for a clutch for my autoshift. This has not been put to the test but I think it will work fine. I will put an air regulator in the line so I can adjust the pressure. I am sure you will have to give your Prevot anti rejection meds if you use this system.
Also I know Prevost uses a clutch pedal system that works just fine. You can find it at the H3-40 parts manual under clutch pedal. I looked hard at this system but did not have the room and you have to fill it through the dash. And I did not want to give my Eagle anti rejection meds.
Wayne
Here is a direct link to Wayne's project page:
http://www.eaglesinternational.net/forum/viewtopic.php?f=9&t=52 (http://www.eaglesinternational.net/forum/viewtopic.php?f=9&t=52)
No matter what your interest, this is a must read thread!!!! His project is beyond description!!
Jim
Ask and ye shall receive Thanks!. I by some chance have all the components including air assist cyl to make it up. Also was what I was just looking at before I came down for lunch. Good timing! Awesome web page well done. Taking care of us poor prevost guys! will get shot! Bob