Text only | Text with Images

BCM Community

Bus Discussion => Bus Topics ( click here for quick start! ) => Topic started by: harpold700 3 on April 01, 2011, 06:37:56 PM

Title: mc7 tag
Post by: harpold700 3 on April 01, 2011, 06:37:56 PM
It would appear I have too much air in my tag. Where is the pressure regulated at?
Title: Re: mc7 tag
Post by: Highway Yacht on April 01, 2011, 07:00:17 PM
I believe mine is located on my MC-9 on the wheelwell just inside the Compressor Compartment door..
Title: Re: mc7 tag
Post by: thomasinnv on April 01, 2011, 08:50:12 PM
should be a regulator located on the vertical bulkhead just above the rear of the engine if that makes sense.  easiest access, at least for me, is through the curb side engine access door.  Da Book says it should be 35psi. 
Title: Re: mc7 tag
Post by: Chopper Scott on April 02, 2011, 06:21:37 PM
I had to replace mine as it was leaking. As stated it's on the curbside bulkhead. Basically just north of the power steering pump. I got mine from Luke. I couldn't find a part number in my books but he knew.
Title: Re: mc7 tag
Post by: harpold700 3 on April 02, 2011, 09:51:57 PM
Thanks, checked pressure and it was to the moon, regulator fubar. Picked up new regulator will install tomorrow.  Gord
Title: Re: mc7 tag
Post by: JohnEd on April 02, 2011, 11:11:36 PM
What was your indication that the tag pressure was up?  Driving symptom?  Harsh ride?  Hunch? :D ;D

Thanks,

John
Title: Re: mc7 tag
Post by: harpold700 3 on April 03, 2011, 09:03:11 AM
Able to do burn outs anywhere, everywhere, all the time. Tag quite effectively took the load off the drivers.  Gord
Text only | Text with Images