BCM Community
Bus Discussion => Bus Topics ( click here for quick start! ) => Topic started by: busme66 on March 02, 2011, 02:03:48 PM
How do you make a M11 select plus and a Alision 748b
link when the trans was hooked to a 6v92 manual
non DDEC. I guess what I'm asking is how to link
up the TPI it has three wires but hooks to a
small box to which has the end of a cable that
goes to a linkage on top of the gov. any help?
If the HT748 is now behind a mechanical 6V-92TA, you have to get a throttle position modulator for your transmission. It is an electronic throttle position sensor that can just hook into the throttle at the engine governor. Relatively easy. Good Luck, TomC