BCM Community

Bus Discussion => Bus Topics ( click here for quick start! ) => Topic started by: Dave5Cs on September 29, 2010, 08:54:19 AM

Title: Ceiling mount for Flat panel help.
Post by: Dave5Cs on September 29, 2010, 08:54:19 AM
Anyone out there use a ceiling mount and if so where can I find one for a Westinghouse 27 inch Flat panel TV.
I have a MC5C and just ran out of room and need to put it up on Ceiling at front so it can be moved down and from side to side. Most seem just to fold up and down and don't swivel or am I just not finding the correct ones.

Thank You Dave


Title: Re: Ceiling mount for Flat panel help.
Post by: Ncbob on September 30, 2010, 01:22:17 PM
Jim Robinson made a beautiful ceiling mount in his 5C from I think a rear engine door latch. You'd have to contact him, if he's still on the Board...he sold his bus. He's JJR  (I think) in the Members list...or Jack Conrad could help you in contacting him.

NCbob
Title: Re: Ceiling mount for Flat panel help.
Post by: Dave5Cs on September 30, 2010, 11:13:01 PM
NCBOB
Thank you, I found his E-mail and sent hm a message. Turns out we both have 5C Saudi Buses also.

Dave
Title: Re: Ceiling mount for Flat panel help.
Post by: Ncbob on October 01, 2010, 02:20:10 PM
Thanks appreciated. At my age anything I offer is usually worth exactly what it cost you but in this case I had a viable answer. Score one for the common herd!

NCbob
Title: Re: Ceiling mount for Flat panel help.
Post by: Dave5Cs on October 02, 2010, 10:07:30 AM
NCBOB

Jim E-mailed me back and said he has sold the bus and that he some photos on his photobucket site which I looked at and got a good idea what it looks like. He also mentioned he had a 12 inch roof raise which I don't. Said he had over 100 hour in making that mount. He made it 1st out of cardboard then wood 3 times. Thaks again for the info. Real helpful guy.

Dave
Title: Re: Ceiling mount for Flat panel help.
Post by: Ericbsc on October 02, 2010, 05:14:59 PM
Look at moview.com. They have mounts that allow the tv to swing up.
Title: Re: Ceiling mount for Flat panel help.
Post by: davido on January 18, 2011, 07:41:58 PM
Dave, are there pictures of this mount online somewhere? I'm looking to do something along those lines right now also.
Title: Re: Ceiling mount for Flat panel help.
Post by: Ericbsc on January 18, 2011, 07:47:57 PM
Got mine here.

http://www.moview.com/full-motion-wall-mounts (http://www.moview.com/full-motion-wall-mounts)
Title: Re: Ceiling mount for Flat panel help.
Post by: Dave5Cs on January 18, 2011, 08:17:09 PM
Davido;

JJRbus did it and I e-mail him. He is on this board. Her is his link to the  3t page of his Ceiling mount he made. Pretty nice unit he made out of wood. He said he had about 100 hours in it. I finally made a wall mount at the front that swings out and I can take it down when traveling by just lifting it up and out.


http://photobucket.com/buspictures (http://photobucket.com/buspictures)

Dave