BCM Community
Bus Discussion => Bus Topics ( click here for quick start! ) => Topic started by: robertglines1 on April 10, 2010, 10:34:06 AM
I have a single headlight prevost that the lights were fogged and turn signals missing(rebuild shell) used a 88 ford f-150 headlight assembly.was not a bad job to install..came with headlights and turn signals...used prevost original housing brackets and tacked welded two brackets to them to mount turn signals to...could just remove prevost complete assembly ;buckets and all and cut down ford housing to fit hole:I just modified the prevost stainless steel bracket and used longer bolts thru existing holes after removing the built in thread inserts..looks good only a true prevost nut would squint at them....used the longer stock prevost adjusting rods for headlight adjustment.complete cost $159..happy bussing Bob.
Removed
not much to show yet..preped for slides.pick. up 60 series and eaton autoshift next thursday..need center section for rear end..will post pictures.yes I am taking pictures..will take some of headlight mod if anyone is intrested..very easy to do.
Interested? Are you kidding? Post lots of pics.....Please.
Thank you,
John