Print Page - Bearing/Hub Tool.

Title: Bearing/Hub Tool.
Post by: johns4104s on April 23, 2009, 06:10:58 PM

I have seen the disc with the two holes that is screwed down to hold the bearing in looking like it was tightend with a hammer and chisel. Where do I buy a wrench with the two claws to tighten the bearing correctly? Do large truck places carry them?

Thanks

John

Title: Re: Bearing/Hub Tool.
Post by: Dreamscape on April 23, 2009, 06:52:48 PM

John, Try NAPA, if they don't have what you need they'll get it for you.

Good Luck,

~Paul~

Title: Re: Bearing/Hub Tool.
Post by: JackConrad on April 24, 2009, 04:28:45 AM

Here is one I made from a scrap of 1" square tubing a couple big spikes (cut off) and a 7/16" nut. All it took was a few minutes to drill 2 holes and a few tack welds to hold the pieces in place.

Title: Re: Bearing/Hub Tool.
Post by: gumpy on April 24, 2009, 04:53:43 AM

Here's the one I made. I used a nut from the back of a wheel stud so I'd have something to put a socket on.

Jack's looks easier.

BCM Community

Bus Discussion => Bus Topics ( click here for quick start! ) => Topic started by: johns4104s on April 23, 2009, 06:10:58 PM