I thought I would let everyone know a friend of mine owns a local saw mill and I mentioned to him what it would cost to cut
some large ramps for my bus. I had read some where on the board awhile back that someone mentioned it was expensive.
Around $50.00 a set he said. I apologize if I'm not suppose to post this here.
Steve 5B....
No need to apologize, good post. I think "large" could be a little better defined. Jim
I have learned somewhere that the ramps should be wide enough to accommodate both rear wheels.
Sorry, I forgot to mention the size, it was indeed the width of the rear wheels. So you could have the SAFTY for the front.
Steve 5B.......
I bought two railroad ties and cut them in half and beveled the ends
I put one under each of the drives and can just drive up on them and I usually carry them with me buried in a bay
HTH YMMV
Melbo